Airworthiness Directives; The Boeing Company Model 737-100, -200, -200C, -300, -400, and -500 Series Airplanes

The FAA is superseding an existing airworthiness directive (AD), which applies to all Model 737-100, -200, -200C, -300, -400, and -500 series airplanes. That AD currently requires repetitive inspections to find cracks, fractures, or corrosion of each carriage spindle of the left and right outboard mid-flaps, and corrective action if necessary. That AD also currently requires repetitive gap checks of the inboard and outboard carriage of the outboard mid-flaps to detect fractured carriage spindles, and corrective actions if necessary. This new AD requires any new or serviceable carriage spindle installed per the requirements of the existing AD to meet minimum allowable diameter measurements taken at three locations. This AD also requires new repetitive inspections, measurements, and overhaul of the carriage spindles, and applicable corrective actions. In addition, this AD requires replacing any carriage spindle when it has reached its maximum life limit. This AD results from reports of fractures that resulted from stress corrosion and pitting along the length of the spindle and spindle diameter, and additional reports of corrosion on the outboard flap carriage spindles. We are issuing this AD to detect and correct cracked, corroded, or fractured carriage spindles, and to prevent severe flap asymmetry, which could result in reduced control or loss of controllability of the airplane.