Airworthiness Directives; Airbus Airplanes
We are superseding Airworthiness Directive (AD) 2014-08-01, which applied to all Airbus Model A318, A319, A320, and A321 series airplanes. AD 2014-08-01 required an inspection for part numbers of the interconnecting struts and, for affected interconnecting struts, identification of the part and serial numbers of the associated target and proximity sensors and replacement or re-identification of the flap interconnecting strut if necessary. This AD continues to require an inspection to verify the interconnecting strut part number. This AD also provides a new compliance time and an additional inspection for previously inspected airplanes. This AD was prompted by an investigation that showed that when a certain combination of target/ proximity sensor serial numbers is installed on a flap interconnecting strut, a "target FAR" signal cannot be detected when reaching the mechanical end stop of the interconnecting strut. We are issuing this AD to address the unsafe condition on these products.