The proposed research is focused on fundamental advances in the field of Dynamic Nuclear Polarization (DNP) NMR that will make this powerful technique far more readily available and useful to the national and international biomedical research communities. In DNP NMR, a high frequency microwave source is used to irradiate electron- nuclear transitions, thereby transferring the high spin polarization in the electron spin reservoir to the nuclear spin system through hyperfine and dipolar interactions. The resulting enhancements in NMR signals have been demonstrated to exceed a factor of 400, and thus DNP NMR is now considered a major advance in NMR spectroscopy. The required microwave frequency for the excitation of the electron spin system is in the terahertz regime: 263 GHz, 395 GHz and 527 GHz for 400 MHz, 600 MHz, and 800 MHz 1H frequencies respectively. To date, DNP for magic angle spinning (MAS) NMR experiments has relied on gyrotron oscillators with continuous power output of tens of Watts. Gyrotrons are now commercially available and more than 40 such systems have been installed worldwide in the past decade. However, gyrotrons for DNP are very costly, exceeding the $600k cost limit for NIH Shared Instrument Grants. Gyrotrons are also relatively large, creating additional issues with the demand for lab space and siting. The main thrust of the proposed research is to radically reduce the required power levels for DNP/NMR down to the point where smaller and cheaper sources are available, including terahertz klystrons and solid-state sources. This will be done by dramatically improving the coupling of power to the sample and by significantly improving the transmission efficiency of the transmission lines. We propose these specific research activities: 1.) We will use state-of-the-art electromagnetics simulations to optimize the coupling of the microwave power from the launching antenna in the DNP NMR probe to the biochemical sample of interest. Preliminary results show that an optimized system can reduce the needed terahertz power by a factor of five, sufficient to allow replacement of the gyrotron by a lower power source. We will use our electromagnetics simulations to design, build and test EPR resonators with higher quality factors in order to more efficiently couple the terahertz power. 2.) In order to design optimized coupling of the terahertz power to the sample, we must know the complex permittivity (real and imaginary ε) of the biochemical samples at cryogenic temperatures. We will measure the sample permittivity using a vector network analyzer. 3.) The efficient transmission of the output power from the terahertz source to the DNP/NMR sample is an advanced microwave engineering challenge. We will conduct experimental and theoretical research to reduce all transmission losses. 4.) We propose to build and test a powerful gyroamplifier for pulsed DNP at 527 GHz / 800 MHz (16T magnetic field), where high resolution DNP experiments are curre...