NHTSA complaint: 2004 FORD CROWN VICTORIA — ENGINE AND ENGINE COOLING
type: Event
additional type: https://schema.org/AccidentReport
start date: 2012-04-15
description: DRIVING S ON M-10 FROM I-94 TO I-75 ENTRANCE RAMP. I ENTERED THE RAMP AT 25- 30 MPH WHEN THE STEERING LOCKED UP, I COULD NOT TURN THE WHEEL. BEFORE I KNEW IT I HIT THE CURB AND THEN ROLLED OVER APPROX. 3 TIMES DOWN AN EMBANKMENT AND FINALLY HITTING A CONCRETE BARRIER WHICH STOPPED THE CAR. AFTER THE ACCIDENT, THE HEAT SHIELD FROM THE DRIVERS SIDE EXHAUST MANIFOLD WAS FOUND UNDER THE CAR, YOU COULD SEE IT RUSTED OFF AND YOU COULD SEE THE MARKS ON IT WHERE IT JAMMED THE STEERING SHAFT AND THE ENGINE BLOCK (STILL HAVE THE PART). BECAUSE OF THE COST CUTTING IN MATERIALS IN THE MANUFACTURING OF THIS HEAT SHIELD OUT OF SHEET METAL AND NOT OUT OF STAINLESS STEEL IT IS THE CAUSE OF THIS ACCIDENT. NOW BECAUSE OF THIS INFERIOR DESIGN AND THE ACCIDENT IT CAUSED, I'M DEALING WITH TBI, PTSD, PBA, NECK INJURY, LOWER BACK INJURY (WHICH IS AFFECTING MY LEGS MAKING IT DIFFICULT TO WALK). A FEW DAYS BEFORE THE ACCIDENT I GRADUATED WITH A BACHELORS DEGREE IN MARKETING, BUT NOW BECAUSE OF MY INJURIES I AM UNABLE TO WORK. THIS NEEDLESS ACCIDENT HAS CAUSED ME FINANCIAL HARDSHIP, I LOST MY HOME, UNABLE TO PAY MY STUDENT LOANS, UNABLE TO PAY MY BILLS. THIS ALL STEMS FROM SOMEONE AT FORD'S DECIDING TO CUT COSTS IN THE MANUFACTURING OF THE HEAT SHIELD OUT OF SHEET METAL INSTEAD OUT OF STAINLESS STEEL. FORD SHOULD HAVE REALIZED THAT A MAJORITY OF THESE CROWN VICTORIA'S ARE OWNED IN AREAS WHERE SALT IS USED IN THE WINTER. YOU WOULD THINK FORD'S BEING LOCATED IN DEARBORN, MICHIGAN WOULD USE COMMON SENSE
organizer: Ford Motor Company
publisher: AI Analytics
license: https://creativecommons.org/publicdomain/zero/1.0/
source: https://www-odi.nhtsa.dot.gov/downloads/
source organization: National Highway Traffic Safety Administration — Office of Defects Investigation

PropertyValue
property ID: NHTSA Complaint ID
value: 1054256

AI Analytics
type: Organization