The issue involves the upper corners of all four door frames on my 2024 Chevrolet Trax, which are extremely sharp. The vehicle is available for inspection upon request. On approximately May 13, 2024, and again on August 16, 2025, my passenger in the front seat was struck in the face by the sharp door frame corner, while exiting the vehicle. In both incidents, the corner cut my passenger's cheek below the eye, resulting in small open wounds, which needed to be cleaned and disinfected. The problem has occurred twice under normal use. I reported the first incident to General Motors (GM) on May 15, 2024, but did not receive a response. On Sept 22, 2025, I reported the second incident that occurred on Sept 2, 2025, to GM, at which time they asked several questions and requested photos of my vehicle, which I provided. On Sept 22, 2025, GM requested I take my vehicle to my dealership, J.B.A. Chevrolet, for inspection. I took my vehicle to JBA on Sept 29, 2025, and was told that GM wanted photos of my vehicle, as well as photos of another 2024 Trax on the Lot for comparison. At that time, JBA had to wait for another vehicle to come in. Unknown if JBA or GM attempted to reproduce the issue during an inspection. On Oct 24, 2025, GM telephoned and issued a final determination, which I requested in writing and received on Nov 11, 2025. GM stated that because the design was consistent across Trax vehicles, and based on the facts provided, they were unable to assume responsibility for