← NHTSA ODI investigations

NHTSA Defect Petition DP15007

Defect Petition · Low-speed surging · Opened 2015-10-19 · Closed 2016-02-25

Investigation

Action number
DP15007
Type
Defect Petition
Open date
2015-10-19
Close date
2016-02-25
Manufacturer
Toyota Motor Corporation
Affected makes
LEXUS
Affected components
VEHICLE SPEED CONTROL
Affected model years
2010
Affected (make, year) variants
1

Summary

In a letter dated September 15, 2015, a consumer submitted a petition to the National Highway Traffic Safety Administration (NHTSA) alleging that software defects caused an accident experienced by his wife in their model year 2010 Lexus HS250H vehicle as she was attempting to park the vehicle. The petition requests that NHTSA have Toyota correct software defects in their electronic throttle control software and then issue a national recall of all effected [sic] vehicles and have Toyota replace the old faulty code with the new safer code. NHTSA has reviewed the material cited by the petitioner.The results of this review and our evaluation of the petition are set forth in the DP15-007 Petition Analysis Report, published in its entirety in the Federal Register and included in the repository for this investigation, available at www.safercar.gov. The Agency performed a thorough technical review of the concerns raised in the petition.The petitioner believes that the information from the Event Data Recorder (EDR), which records certain pieces of information for five seconds prior to a crash, shows that for the last 0.8 seconds prior to hitting the brick building the accelerator pedal was wide open at 100% at the same time the brake pedal was being depressed. Our analysis of data recovered from the EDR and from the engine management Hybrid Control Unit (HCU), together with vehicle inspection information contained in the petition, indicate that:1) Sometime during the last 0.512 seconds of the event time frame the accelerator pedal was fully applied; 2) At the airbag trigger point (EDR t = 0s) immediately following the vehicle's impact with the building, the stop lamp switch status was ON, indicating that the brake had been applied at least enough to illuminate the brake lights; 3) At no time during the event were the brake and the accelerator pedals depressed simultaneously (based on information from the HCU); and 4) The braking system on the vehicle was fully functional and

Source

Authoritative
NHTSA ODI investigation page
Machine
JSON-LD · Markdown