NHTSA Preliminary Evaluation PE21004

The Office of Defects Investigation (ODI) opened this Preliminary Evaluation to investigate reports of engine electrical wiring harness chafe on the subject vehicles.ODI analysis found thousands of unique harness part numbers, spanning the two generations of vehicle chassis assembled at multiple vehicle assembly plants in two different countries, with multiple sub-models, incorporating over thirty powertrain choices.Each wiring harness could contain several dozen individual wires for power, ground and communication purposes depending on the multitude of equipment options available for custom vehicle configuration. ODI identified three primary areas where a wiring harness bundle may chafe: the air compressor support bracket, the transmission case, or the coolant surge tank. In each case, the root cause was some combination of inadequate design clearance, installation variability and relative motion between the wiring harness and the point of contact, such as from vibration. The chafing could result in a range of consequences from none to various diagnostic fault codes, telltale illumination, driver warning center messages, erratic electrical component operation, difficult or no engine start condition, engine de-rate (power reduction), engine shut down, inoperative transmission gear selection, or an unexpected shift to neutral.These potential consequences vary depending on the specific damaged wire in the harness and the exact failure mode, such as intermittent short circuit to ground or open circuit. Generally, the chafing resulted in a progressive series of driver warnings with high levels of detectability over the course of several days and ignition cycles. Drivers usually heed warnings before an engine shutdown condition occurs and the driver may override an engine shutdown countdown timer using the override switch. If the driver allows the shutdown event to occur, the engine can almost always be immediately restarted. Incident rates for an engine shutdown with no