The vehicle has a safety system called hill assist start and auto hold braking. When activated the driver can take their foot off the brake pedal when fully stopped and the car should stay stopped until the accelerator is engaged. The first incident occurred about 5 months ago. I had started the vehicle and put it in drive. A warning then appeared on the dashboard saying hill assist start fault and then immediately switched to auto hold fault and the car started moving on its own. After stopping the car and resetting the transmission the fault message went away and the car held in place. About 2 weeks later this same fault happened but I was unable to stop the car in time before hitting a pole on the left front quarter panel. This caused a large dent. I was able to take a picture of the fault message on the dashboard. I had to take the car in for another issue and told the service advisor about the auto hold faults. The dealer ran a diagnostic and found no issues. The issue did continue after this visit. About 2 months ago the fault occurred when the car was next to a wall and the front left side was heavily damaged when it hit the wall. I was able to take another picture of the fault message. At the same time, we had issues with getting the car into reverse on the transmission dial Returned to the dealership and informed them of the continued issues. I also opened a case with Ford over the issue. The dealer again ran a diagnostic, drove the car but could not reproduce any of